There are currently five mounting options for the golf club and ball washer:

1. Fender mount without bracket
2. Fender mount with bracket
3. Post mount with plastic bracket
4. Post mount with metal bracket
5. Suction cup mount

1. Fender mount without bracket

This fender mount solution does not require a bracket and is adaptable to most flat surfaces. Use the template included with every unit to mark and drill holes where you would like the unit mounted. Then use the screws, also included, and screw up through the underside of your flat surface into the unit. DO NOT OVER TIGHTEN.

2. Fender Mount with bracket 

The fender mount bracket allows you to mount your club and ball washer to most flat surfaces. The measurement to the center of the holes are for the back two width, 5 9/16", the front two width, 4 7/8" and the length, 5 11/16". Once attached to the bottom of the unit, this bracket allows the unit to be attached with screws or double sided tape from above the fender or other surface. This eliminates the need to crawl underneath your golf cart.

3. Post Mount with Plastic Bracket

This high-impact plastic mounting bracket fits top posts on most golf carts and has a rotatable disk to aid in leveling. Spacers are included for EZ-GO (3/4" x 1-3/4" post) and Club Car (1" x 2" post) as well as a 1" x 1" spacer. This mounting system can also be used to mount the club and ball washer to the sweater basket found on many golf carts.

4. Post Mount with Metal Bracket

This metal bracket fits top posts on most golf carts and can be used to mount the club and ball washer to the sweater basket found on many golf carts.

5. Suction Cup Mount

The suction cups attach to the bottom of the club and ball washer and allow you to mount the unit on any clean, smooth surface. WARNING: The suction cups are not as secure as the other mounting systems and may not hold the unit in place when driving over bumps.